Newbie
Hi forumers,
I went to hansgrohe to look for rain shower system, was told the minimum water pressure is 3 bar to supports it. [/LIST]How to verify that condo water pressure meet this requirement![/LIST]The unit is on highest floor, would it reduced it pressure?
Any experience to share?
Junior
You got to raise the question to the M.C . 3 bar is quite high....is it rated operating pressure at 3 bar?Originally Posted by Abcd1234
Other thing is check your riser pipe is fully opened?
tweet @condoexchange
水压非水*。。。 最好弄清楚再买
웹뷰에서 각종 플러그인 실행가능
Last edited by carbuncle; 07-08-12 at 14:50.
Junior
Bro , Korean wording plus #*+ ...
You scold who?
dreaming a dream
boss, u into korean?
Junior
Water pressure, from direct PUB , varies from elevation of the place. Most of the water can tap the PUB pressure if the height not exceed 25 m above sea water Any thing above 25 need to be stored as water energy. Above 37 meter needs to be supplied via pumping system
Usually depending on your development, if it is a pump system, it is usually set at 2 bars to conserve energy.
Your MC should able to advise if it is set which bar, depending on your block height,, some is as high as 4 bar for those very high rise block.
Hope that help.
Btw, your shower set need very high pressure...
tweet @condoexchange
Nah.... just doing some testing ::P
tweet @condoexchange
没有啦。只是在做测试。哈哈
必ず
Setpluginsenabled(true), guess that's what the hangul says?
Posting Permissions
Reply With Quote